This Product Has Been Discontinued and Replaced with a NEW version by Axalta (formerly DuPont) Imron 3.5 HG+ Series
Imron® 3.5 HG™ high gloss aliphatic polyurethane enamel is a high-solids, two-package, VOC conforming product (3.5 lbs./gal.) based on patented DuPont resin technology, producing properties of both polyester and acrylic polyurethanes. The resulting highly durable finish delivers industry leading polyurethane performance.
As a high performance topcoat over suitable primers or tie coats on steel, galvanized steel, stainless steel, aluminum, concrete, concrete block, fiberglass, plastics and wood where:
♦ Outstanding gloss and color retention are desired.
♦ Excellent resistance to chemical and/or marine environments is required.
♦ Outstanding abrasion resistance and flexibility are required.
♦ Application by brush and roller, in addition to spraying, may be necessary.
♦ Application must be made at temperatures as low as 35° F.
♦ Mechanical surface preparation will be prohibited or impractical later when recoating.
NOT RECOMMENDED FOR: Immersion Service
COMPATIBILITY WITH OTHER COATINGS
Aged Imron® 3.5 HG™ may be re-coated with itself following washing with clean, fresh water – no mechanical surface preparation is required. See Additional Comments #4
Imron® 3.5 HG™ can be applied over other DuPont Industrial Coatings including, but not limited to, Imron® waterborne polyurethane copolymer coatings, Corlar® epoxies, Tufcote® acrylics, Tufcote® alkyd primers, and DuPont WP™ wash primer.
Imron® 3.5 HG™ may be used over most aged and hard-cured coatings in good condition. Testing for lifting, bubbling and adhesion is recommended to assure compatibility with unknown coatings. Contact your DuPont Performance Coating representative for specific recommendations.
MAXIMUM SERVICE TEMPERATURE
250°F (93°C) in continuous service.
300°F (148°C) in intermittent heat.
Some yellowing of light colors may occur at elevated temperatures.
Newly primed surfaces should be clean and dry. If contaminated, detergent/water wash, then blow dry. Previously painted surfaces should have all loose paint removed and the edges feathered. Prime bare spots with appropriate primer.
Thoroughly mix 4 parts Imron® 3.5 HG™ (42P™ Custom Color), then add 1 part Imron® VGM-6005™ Activator while stirring. No induction period is necessary.
♦ Apply by spray, brush or rollSee Product Data Sheet for cure times,reduction, application thinners and additives.
♦ Manufacturers listed below are a guide. Others may be used. Changes in pressure and tip size may be required to achieve proper application.
Size: Gallon (Short Filled 80%)
* Please Note, Special Shipping Rates May Apply To This Product.